LG Repair Experts of Porter Ranch(818)298-8165 Arleta and Following Cities: Valencia | New Hall LG Repair | Simi Valley LG Repair | Agoura Hills LG Repair | Calabasas LG Repair | Woodland Hills LG Repair |  LG repair Canoga | LG Repair Reseda | LG Repair Tarzana | LG Repair Pasadena | LG repair Glendale, CA | LG repair Beverly Hills | LG Repair Los Angeles | LG Repair West Hollywood | LG Repair Santa Monica | LG Repair Venice | LG Repair Malibu | LG Repair San Fernando Valley | LG Repair North Holywood | LG Repair Studio City

Service Call is only $20 | Free Service Call with Authorized Repair | 30 Day Warranty on Labor | 1 Year Warranty on Parts 

Licensed | Insured  (818)298-8165 

You an lg front loader washer. The washer stopped and had an “LE” error message. I turned off the power and closed the water connections. I then waited 12 hours and drained teh washer, turned power on and tried again (read to do that online). I put another load in and it begin to spin and fill with water. Then when the water got full, it would not spin and heard a small noise that sounded like a subway going through a tunnel. Sounded like the motor was trying to spin, but was getting stuck?? 

It doesn’t drain but makes a grinding noise. Took the drain pump out, clean, and checked the conductivity OK something 14.5 ohms. Put everything back together and same thing, tried normal and quick wash cycles on rinse and spin, drained it off the bottom plug.Any idea what’s causing the grinding and not draining. 

This is some of the codes that LG Washing Machines Might Have:

LE = overload in motor
PE = water level sensor malfunction
CE = overload in motor
FE = water overfills due to faulty water valve
PF = washer experienced power failure….restart
IE = water is not adequate , water hose bent, filter inlet hose clogged
OE = drain hose bent/clogged, drain filter clogged
UE = load is too small, load out of balance, imbalance detected
DE = door opened or not complete closed


LG Dryers: some problems that it might have: Does the start/pause button blink also? Depending on some models, go to the end of cycle button and press. That will reset washer or dryer. Then check the water filter or exit hose drain and make sure drain in no higher than 3 feet from ground (washer). Check for dirty lint filter or clogged vent pipe(dryer). dryer started taking longer and longer to dry the clothes . LG Its a super nice dryer and less then 3 years old.  No problem we need the dryer fixed  Something about it coats the sensor ?? Why was that not mentioned in any of the paperwork when we bought it ? : So my questions ?..